History: Pistol Tool

Unlike the Shotgun Tool, the Beretta Pistol Tool does not have a host of features specifically suited towards firearms. As a matter of fact, it seems to be a rather ordinary, made-in-China multitool. Construction is better than most imports, although nowhere near American or European standards. Size is equivelent to a Leatherman Super Tool.

Jaws

Standard semi-needlenose profile, with fine serrations to the tips. Curiously, there is no coarse serrated gripping area in the middle portion of the jaws as is common. Instead, there is a flat section of non-serrated surface.

Also unusual is the anvil-type wire cutter down near the pivot.

Handles/Frame

Handles on the Pistol Tool are folded channels of stainless steel, reminiscent of early Leatherman tools. A large BERETTA logo and crest are laser etched into each side.

Blades and Tools

• half-serrated knife blade, clip point profile, 3" long (76mm)
• combination large screwdriver/cap lifter
• combination medium screwdriver/can opener
• three-sided file blade

• scissors
• full 1/4" hex bit driver, with magnet. The bit driver locks open at both 90 and 180 degrees.

Locking Mechanism

Beretta Pistol Tool

close-up of jaw area

All of the blades and tools lock open using a toggle-lock mechanism.

Other Features

Included with the Beretta Pistol Tool was a set of nine 1/4" hex bits, stored in a plastic strip.

Also included was a small device referred to as a "trigger spring hook" (see pictures)

Sheath

A special sheath came with the Pistol Tool. It had two compartments side-by-side; one for the tool itself and one for the accessories. Construction was woven nylon with velcro closure. Vertical carry only. (see photo at top of page)

Dimensions

• Folded length = 4.5" (114mm)
• Unfolded length = 7" (178mm)
• Thickness = .63" (16mm)
• Weight = 7.8 oz (220g)

Variations

None.

Background

First noted in 2004. Made in China.

Related Tools

None.

More Info